不銹鋼封頭的熱沖壓成型工藝過程說明
在封頭沖壓成型時，為了降低坯料與模具間的摩擦力，沖壓成型時大都在下模的表面涂以潤滑劑。不銹鋼封頭沖壓成型，一般使用的潤滑劑為55%石墨＋45%機油。封頭沖壓設備及成型過程見圖4-30. 壓力機噸位的選擇：毛坯厚度8=30~40mm,壓力機噸位應≤400噸，毛...
